How to Draw a Bear

پړاو په پړاو

1. پړاو 1

   Draw the ribcage first. It is the biggest mass in the bear.

   The ribcage is the largest single mass in almost every four-legged animal, and drawing it too small is the most common structural error in the whole category. Draw it in one motion and make it bigger than feels right.

   پاملرنه Drawing the chest small to leave room for everything else.

   کتنه The chest oval should take up around a third of the body's length on its own.

2. پړاو 2

   Put in the hip mass - smaller than the chest on almost every animal.

   The gap between the two masses is information: it is most of what separates a long animal from a compact one. Decide the gap deliberately rather than letting it happen.

   پاملرنه Butting the pelvis directly against the chest.

   کتنه You should see clear space between the two ovals.

3. پړاو 3

   Join the two ovals with a single spine curve.

   One continuous curve, drawn in one pass. The spine sets the whole animal's attitude, and a spine assembled from three short strokes reads as three different animals stitched together.

   پاملرنه Drawing the spine as separate flat segments.

   کتنه The curve should touch both masses without a corner.

4. پړاو 4

   Place the head mass and rough in where the neck goes.

   Note where the neck leaves the chest before you place the skull - on most animals it comes off the front of the chest mass, not the top, and that single angle carries the species.

   پاملرنه Hanging the head above the body instead of in front of it.

   کتنه The neck guide should leave the FRONT half of the chest oval.

5. پړاو 5

   Thicken the neck: one curve on top, one underneath.

   A neck is a solid with real thickness, and on most animals it is thicker than you think - nearly as deep as the head itself. Two curves, one over, one under.

   پاملرنه A thin stick neck, which makes any animal look fragile.

   کتنه The neck should be nearly as thick as the head is tall.

6. پړاو 6

   Connect the two ovals along the back and along the underside.

   This is where the animal stops being two eggs. Let the topline follow the spine you already drew and keep the belly line taut - a sagging belly is a decision, not an accident.

   پاملرنه Ignoring the spine curve you drew and inventing a new back.

   کتنه The topline should agree with the spine curve underneath it.

7. پړاو 7

   Draw the belly line underneath.

   The belly is a separate decision from the masses: it hangs below the line joining them, sagging most midway, and how much it sags is part of the animal - taut on a deer, generous on a cow. Draw it as one curve, not two arcs meeting.

   پاملرنه A straight line between the ovals, which reads as a table.

   کتنه The belly should dip below both mass bottoms at its middle.

8. پړاو 8

   Add the two closing curves - chest front, rump.

   Two curves seal the body into one shape: down the front of the chest into the belly, and from the top of the hips around the rump to meet it. Without them the animal has no front or back and the legs float - this is the step that turns parts into a body.

   پاملرنه Leaving the ends open because the ovals suggest them.

   کتنه You should be able to trace the whole body without lifting your pen.

9. پړاو 9

   Draw the two front legs as chains from shoulder to foot.

   Legs are chains of segments with a joint at each bend, and every leg bends somewhere. Draw joint to joint in straight strokes first; curves come later if at all.

   پاملرنه Straight tube legs with no joints, which read as furniture.

   کتنه Each front leg should bend at least once.

10. پړاو 10

    Draw the back legs against the front ones for length.

    The hind legs fold the opposite way to the front pair - the hock points backwards. Compare their length against the front legs rather than judging them alone.

    پاملرنه Back legs bending the same way as the front ones.

    کتنه Front and back feet should reach the same ground line.

11. پړاو 11

    Place the ears, and get their shape right.

    Ears attach further back on the skull than feels natural, and their shape is one of the strongest species signals you have. Draw the second by comparing it to the first.

    پاملرنه Planting the ears on top of the head like handles.

    کتنه Both ears should attach behind the midpoint of the skull.

12. پړاو 12

    Draw the muzzle projecting forward from the head.

    The muzzle projects forward from the lower half of the head mass. Its length relative to the skull is the proportion to measure - it is the one that changes species when you get it wrong.

    پاملرنه A muzzle pointing down instead of forward.

    کتنه The eye should sit in the top half of the head mass.

13. پړاو 13

    Draw the tail and the details that say bear rather than animal.

    Detail is suggested, never itemised. Put the marks where they identify the animal and stop early - texture spread evenly everywhere flattens the drawing back out.

    پاملرنه Covering the body evenly in fur marks.

    کتنه Step back: the big shapes should still read first.

14. پړاو 14

    Add the eye - iris, pupil, highlight - and the brow above it.

    An eye is built in layers - iris, pupil inside it, one small highlight, and the brow line above that gives it a direction to look. The highlight and pupil must not touch, and the brow is what turns a circle into a gaze. This one feature carries more life than the rest of the head together.

    پاملرنه A single black dot, which reads as a bead.

    کتنه The highlight should sit at the pupil's edge, not inside it.

15. پړاو 15

    Put feet on the bear, each with its toe split.

    A leg without a foot is a pole. One short base line at the bottom of each leg, angled with the ground, plus a single toe split, and all four legs suddenly bear weight. Feet are also where the ground line will attach, so place all four bases at nearly the same height.

    پاملرنه Legs ending in points, or feet at four different heights.

    کتنه All four feet should sit within one pencil-width of the same line.

16. پړاو 16

    Draw the ground line and the cast shadow.

    The ground is one line through the feet, and the cast shadow is one flattened arc beneath the body, darkest between the legs. Together they anchor the animal - without them even a perfect construction floats in white space. Keep the shadow tight under the body; a wide puddle reads as water.

    پاملرنه Skipping it, leaving the animal hovering.

    کتنه The shadow should touch at least two of the feet.

17. پړاو 17

    Break the clean outline with tufts of coat.

    Fur is an edge event: a few tufts where the coat genuinely hangs - chest, belly, rump - and nowhere else. Each tuft leans the way the coat grows, back and down, and the outline should still read as one body between them. This is also where the sealed construction line stops looking mechanical.

    پاملرنه Scalloping the entire outline evenly, which turns any animal into a sheep.

    کتنه Most of the outline should still be smooth between the tufts.

18. پړاو 18

    Put the shadow in: under the belly, behind the shoulder.

    Two or three patches of parallel strokes - under the belly, behind the shoulder - all leaning the same way, and the drawing suddenly has light in it. Keep the patches small: shading in a sketch is a note about where the dark lives, not a rendering.

    پاملرنه Scrubbing tone everywhere, which flattens the sketch it took fifteen steps to build.

    کتنه All the hatch strokes should lean the same direction.

19. پړاو 19

    Go round the keepers heavily, then erase the guides.

    Press harder on the outline and the face, leave the small marks light, and erase the construction ovals. That weight difference is what makes the drawing look decided.

    پاملرنه Going over every line at the same weight.

    کتنه The outline should be clearly darker than the interior marks.