How to Draw an Angelfish
1 / 13
Block in the body as one long oval.
The body should be symmetrical about its long axis.
Vẽ lên giấy thay?
Chúng tôi sẽ làm thẳng và dọn dẹp bức ảnh cho anh, giấy cũng vậy.
Về bức vẽ này
An angelfish is drawn tall, not long: the body is a disc standing on edge, and the dorsal and belly fins extend it into a shape higher than it is wide. Then two or three bold vertical stripes wrap the disc - and wrapping them over the curve is the actual lesson.
Like every fish here, it is one oval with a tail, and everything else - fins, gill, eye - attaches to that oval by overlapping it.
Bước một bước
-
Bước 1
Block in the body as one long oval.
One long oval, drawn fast. Fish bodies are smooth in a way hands are bad at producing slowly, so go round the shape in one continuous motion and keep the best pass.
Cẩn thận! A lumpy body built from careful short strokes.
Kiểm tra The body should be symmetrical about its long axis.
-
Bước 2
Add the tail, about a third of the body length.
The tail is bigger than you think - often a third of the body's length. An undersized tail is the single thing that makes a drawn fish read as a leaf.
Cẩn thận! A small tail tucked against the body.
Kiểm tra The tail should be about a third of the body length.
-
Bước 3
Add the gill line.
One curve, following the round of the head, roughly a fifth of the way along. It separates head from body and does more work than any other single line on the fish.
Cẩn thận! A straight gill line, which flattens the head.
Kiểm tra The gill curve should bow the same way as the nose.
-
Bước 4
Put the eye in and darken it.
High and forward - roughly where the gill curve meets the top third. Round, dark centre, one highlight. Too low or too far back and the fish stops looking alert.
Cẩn thận! Centring the eye in the head.
Kiểm tra The eye should sit above the body's midline.
-
Bước 5
Put the mouth line in.
The mouth sits at the very front, lower than the eye, and it is smaller than instinct says. A short curve is enough - an open grin turns the fish into a cartoon.
Cẩn thận! A large smiling mouth.
Kiểm tra The mouth should be below and forward of the eye.
-
Bước 6
Add the dorsal fin over the back.
Start the fin lines INSIDE the body so they cross the outline. That overlap is what attaches the fin - drawn outside the line it floats like a flag.
Cẩn thận! A fin sitting on the outline without crossing it.
Kiểm tra Fin lines should visibly cross the body outline.
-
Bước 7
Add the belly fin.
Compare it to the top fin, not to your idea of a fin: position, rake and size all read against the one you already drew.
Cẩn thận! A bottom fin that mirrors the top exactly - they rarely match in nature.
Kiểm tra The two fins should differ, deliberately.
-
Bước 8
Add the fin on the near side.
The pectoral fin is the smallest and it sits just behind the gill curve, angled back. It is the one nearest the viewer, so it draws over the body.
Cẩn thận! Making the side fin as big as the others.
Kiểm tra It should be clearly the smallest fin.
-
Bước 9
Add a hint of the pattern.
Suggest, never itemise. A handful of marks near the head lets the eye tile the rest of the body; drawing every scale turns the fish into a texture swatch.
Cẩn thận! Covering the whole body in scales.
Kiểm tra Most of the body should still be empty.
-
Bước 10
Add what makes it a angelfish.
Species markings follow the body's curve and fade toward the belly. Put them on deliberately - they are the difference between a fish and this fish.
Cẩn thận! Markings drawn flat across a curved body.
Kiểm tra Stripes or patches should bend with the form.
-
Bước 11
Shade the underside so it reads as round.
The underside is darker - light comes from above, even underwater in a drawing. One soft band of tone along the belly makes the whole fish read as round.
Cẩn thận! Even tone everywhere, which flattens the body.
Kiểm tra The belly should be clearly darker than the back.
-
Bước 12
Draw three bubbles and two ripples, and stop.
Three bubbles of different sizes rising off the mouth and two long ripple lines are the entire ocean - more reads as boiling. The bubbles shrink as they rise, and the ripples drift horizontal, which is what places the angelfish in water instead of in white space.
Cẩn thận! A column of same-size bubbles, or ripples that wave like flags.
Kiểm tra The bubbles should get smaller as they rise.
-
Bước 13
Go over the keepers and lose the guides.
Darken the silhouette and the tail, keep pattern marks light, erase the construction oval. Weight contrast finishes the drawing.
Cẩn thận! Every line at the same weight.
Kiểm tra The outline should dominate when you squint.
Có vẻ như nó đã kết thúc.
Cùng một bức vẽ với tất cả các đường dẫn bị xóa và chỉ có các đường mà bạn muốn giữ lại, với trọng lượng mà bạn muốn chúng có. Nếu bức vẽ của bạn vẫn còn có đường trung tâm và hình dạng chặn trong nó, đây là bước bạn chưa thực hiện - và nó mất khoảng 30 giây.
Đây là công trình xây dựng với những tấm giáp bị lấy đi, không phải là một bản vẽ mà ai đó vẽ để được ngưỡng mộ - ý là để cho anh thấy những đường nào của anh là đường dẫn.
Điều này thực sự dạy cho anh
What transfers is suggestion over itemisation - a few scale marks that let the eye tile the rest. The same restraint draws leaves, hair and crowds.
The angelfish exists on this site for its stripes: pattern wrapping form is the skill, and a bold stripe on a disc is the clearest possible practice for it - the same logic as the mug's grid and the cow's patches, at difficulty one-point-five.
Thực hành những điều này: Line confidence Proportion Value range
Cái mày cần
A pencil, kept light until the last step, and an eraser you will actually use. The construction is deliberately drawn to be removed.
Nếu nó không ổn
If it looks like a normal fish, the proportions are horizontal. Rotate your thinking: an angelfish with fins is TALLER than it is long, a triangle balancing on its point.
If the stripes flatten the body, they are straight. Each stripe must bow with the disc - curved at the edges, straightest in the middle.
If the fins look stuck on, they continue the body's line: the dorsal fin's front edge flows out of the forehead curve without a corner.
In các bước
Đưa nó ra khỏi màn hình, bảng bước in trên một trang.
Câu hỏi người ta hỏi
- How do I draw an angelfish's stripes?
- Bowed with the body, never straight - each stripe curves at the edges and straightens in the middle, which is what makes the disc read as round.
- What shape is an angelfish?
- Taller than long - a disc on edge, extended by tall dorsal and belly fins into a triangle balancing on its point.
- How many stripes does an angelfish have?
- Two or three bold verticals through body and fins is plenty. More reads as a barcode; the gaps matter as much as the stripes.
- How do I start drawing an angelfish?
- One body oval, drawn fast in one motion, then the tail before any detail. Everything else - fins, gill, eye - attaches to that oval by overlapping it, which is what keeps the parts reading as one animal.
- How big should the tail be on an angelfish?
- Bigger than feels right - about a third of the body length. An undersized tail is what makes a drawn fish read as a leaf.
- Do I have to draw all the scales on an angelfish?
- No, and you should not. A few marks near the head let the eye tile the rest of the body on its own; drawing every scale turns the animal into a texture swatch and loses the big shape you built first.
- Can a beginner draw an angelfish?
- Yes - it is one oval, a triangle and some overlapping fins, with a finish-early step marked partway through.
- Why do the fins on my angelfish look stuck on?
- They are not crossing the body outline. Start each fin line inside the body so it visibly overlaps the oval - that overlap is the attachment, and it is the single trick this whole family of lessons keeps reusing.