How to Draw a Cactus
1 / 12
Lay in one shape, drawn in a single motion.
It should fill most of the page with a margin all round.
Piirustukset paperille sen sijaan?
Suoristamme ja siivoamme kuvan. Paperilla on sama merkitys.
Tästä piirroksesta
A saguaro cactus is a green cylinder with its arms up, and it is on this site for its ribs: the vertical lines running the column's length are contour lines exactly like the pumpkin's segments turned on end, and each arm bends through a perfect elbow - out, then up - that beginners round off into a curve and lose.
The build is the standard solid one - one oval, a corrected silhouette, then shading with a committed light direction.
Askel kerrallaan
-
Vaihe 1
Lay in one shape, drawn in a single motion.
One shape, one motion. A slightly lopsided mass drawn confidently beats a perfect one assembled from nervous strokes, because you can correct a shape and you cannot un-see hesitation.
Varo, mitä teet Building the mass from many small safe strokes.
Tarkista It should fill most of the page with a margin all round.
-
Vaihe 2
Push the outline in and out.
Nothing organic is a perfect oval. Push the outline in and out where the subject actually does - the asymmetry IS the likeness.
Varo, mitä teet Leaving the construction oval as the finished outline.
Tarkista The outline should differ visibly from the oval underneath.
-
Vaihe 3
Add the two centre lines lightly.
Two light lines through the middle are the rulers for everything that follows. Without them the features drift off-centre a few millimetres at a time.
Varo, mitä teet Skipping the axes because the shape looks simple.
Tarkista The two lines should cross near the middle of the mass.
-
Vaihe 4
Draw the top feature.
Whatever sits on top attaches INTO the form, not onto its outline - it comes out of a dip or a mound, and drawing that junction is what attaches it.
Varo, mitä teet Balancing the stalk on the outline like a hat.
Tarkista The top feature should overlap the mass's outline.
-
Vaihe 5
Put the top curve in.
The hollow around the top is what makes the form read as having a top rather than an edge. One curve, and note which way it bows - it tells the viewer where their eye is.
Varo, mitä teet Omitting the dip so the top sits on a flat line.
Tarkista The dip should curve, not sit flat.
-
Vaihe 6
Decide the light source now.
Pick a direction and commit. Every decision from here - shading, highlight, cast shadow - follows from this one, and changing your mind halfway is the classic way a drawing ends up lit from two directions.
Varo, mitä teet Deferring the decision and shading by instinct.
Tarkista You should be able to point at the light source.
-
Vaihe 7
Shade the far side of the form.
Work in one direction and build darkness in passes. Scrubbing back and forth gives an even grey - precisely the thing that makes a drawing look flat.
Varo, mitä teet Scrubbing, and stopping two steps short of dark enough.
Tarkista The dark side should be clearly darker than the mid tone.
-
Vaihe 8
Leave a light strip at the shadow edge.
Leave a thin lighter strip right at the shadow-side edge - bounced light from the surface below. It is the single cheapest thing that makes a form read as round.
Varo, mitä teet Running the shading tight to the outline.
Tarkista A lighter line should separate shading from edge.
-
Vaihe 9
Put one small highlight on the lit side.
One highlight, small, off-centre on the lit side. Two symmetrical highlights read as plastic; a big one reads as wet.
Varo, mitä teet A large or doubled highlight.
Tarkista The highlight should be smaller than your thumbnail.
-
Vaihe 10
Add the identifying surface detail.
Surface marks follow the form - they curve over the mass and fade near the highlight. Flat marks cancel the volume you just shaded into it.
Varo, mitä teet Marks drawn flat across the curved surface.
Tarkista Marks should bend with the surface.
-
Vaihe 11
Draw the shadow on the surface below.
Darkest at the contact point, softer as it stretches away from the light. It anchors the object; without it everything you shaded still floats.
Varo, mitä teet An even grey puddle not touching the object.
Tarkista The shadow should touch the object's base.
-
Vaihe 12
Weight the outline and lose the construction.
Weight the silhouette, erase the axes and the oval, and leave the interior marks light. The weight difference is what makes it look deliberate.
Varo, mitä teet Equal weight everywhere.
Tarkista Outline darkest, marks lightest, guides gone.
Miltä näyttää valmis
Sama piirros jokaisen oppaan kanssa pyyhittynä ja vain ne viivat, jotka aioit pitää, painolla, jonka tarkoitit niiden olevan. Jos oppaassasi on vielä keskiviivat ja tukkeutumismuodot, tämä on askel, jota et ole vielä tehnyt - ja se kestää noin 30 sekuntia.
Sinun ei näytä tältä, eikä sen pitäisikään näyttää. Tämä on rakennus, jossa rakennustelineet on viety pois, ei piirros, jota joku on tehnyt ihailtavaksi - tarkoitus on näyttää, mitkä linjasi olivat oppaita.
Mitä tämä opettaa sinulle
The skill underneath is committing to a light direction before shading anything. Most flat-looking drawings are lit from nowhere in particular, and deciding is the fix.
The cactus is the cylinder's contour lesson grown vertical: rib spacing doing on a standing column what the pumpkin's segments did on a squashed sphere. Same rule, rotated ninety degrees - which is how you know it is a rule.
Harjoittele näitä: Line confidence Proportion Value range
Mitä tarvitset
Anything that makes a mark. On paper, press lightly for the first few steps - most of what you draw early is scaffolding you will erase.
Jos se menee pieleen
If the arms look like bananas, the elbow is missing: a saguaro arm goes OUT horizontally then turns UP through a near-right angle - two moves, not one curve.
If the ribs flatten it, they are evenly spaced: ribs crowd together at the column's edges and spread in the middle, which is what makes the cylinder turn.
If the spines read as fur, there are too many: a few short ticks along the ribs, in pairs, sparser than feels thorough.
Tulosta vaiheet
Ota se pois näytöltä.
Kysymyksiä
- How do I draw cactus arms?
- Out horizontally, then up through a near-right angle elbow - two distinct moves. Rounding the elbow into one curve turns the arm into a banana.
- How do I draw the ribs on a cactus?
- As vertical contour lines, crowded at the edges of the column and spread in the middle. The uneven spacing is what makes the cylinder read as round.
- How many spines should I draw on a cactus?
- Far fewer than the plant has: short paired ticks along the ribs, sparser than feels thorough. Dense spines read as fur and soften the whole form.
- Can I draw a cactus on paper instead of the canvas?
- Yes, and for a shading lesson paper is arguably better - a soft pencil gives you more range than a finger on glass. The printable sheet has every step, and a photographed result is measured the same way.
- How do I start drawing a cactus?
- One oval, drawn in a single motion, then correct the silhouette where the real thing differs. The oval is scaffolding, not the outline.
- How do I shade a cactus?
- Pick a light direction and commit, shade in one direction in passes, keep the darkest band just inside the edge, and leave one small off-centre highlight.
- Why does my cactus look flat?
- Almost certainly range - no true dark anywhere and no untouched light left on the page. Go two steps darker than feels safe and leave the highlight alone.
- Can a beginner draw a cactus?
- Yes - it is deliberately one of the simpler forms here, chosen so the shading can be the whole lesson.
- Does a cactus need a cast shadow?
- Yes, always. Without one the form floats on the page however carefully you shaded it. Darkest at the contact point, softer as it stretches away.