How to Draw a Tiger
1 / 14
Block in the ribcage as one big oval.
The chest oval should take up around a third of the body's length on its own.
Drawing on paper instead?
We straighten and clean up the photo for you. Paper counts exactly the same.
About this drawing
A tiger is the lion's construction wearing the zebra's problem: a big cat whose stripes have to wrap a body built of curves. But tiger stripes have their own grammar - they are broken, tapered at both ends, and they run TOP-DOWN off the spine like paint pulled by gravity, densest over the shoulders and haunches.
Underneath, this is the same two-ovals-and-a-spine build as every other animal here; what changes is the ratio between the masses and the gap separating them.
Step by step
-
Step 1
Block in the ribcage as one big oval.
The ribcage is the largest single mass in almost every four-legged animal, and drawing it too small is the most common structural error in the whole category. Draw it in one motion and make it bigger than feels right.
Watch out Drawing the chest small to leave room for everything else.
Check The chest oval should take up around a third of the body's length on its own.
-
Step 2
Put in the hip mass - smaller than the chest on almost every animal.
The gap between the two masses is information: it is most of what separates a long animal from a compact one. Decide the gap deliberately rather than letting it happen.
Watch out Butting the pelvis directly against the chest.
Check You should see clear space between the two ovals.
-
Step 3
Join the two ovals with a single spine curve.
One continuous curve, drawn in one pass. The spine sets the whole animal's attitude, and a spine assembled from three short strokes reads as three different animals stitched together.
Watch out Drawing the spine as separate flat segments.
Check The curve should touch both masses without a corner.
-
Step 4
Put the skull in, and mark the line from chest to head.
Note where the neck leaves the chest before you place the skull - on most animals it comes off the front of the chest mass, not the top, and that single angle carries the species.
Watch out Hanging the head above the body instead of in front of it.
Check The neck guide should leave the FRONT half of the chest oval.
-
Step 5
Draw both sides of the neck.
A neck is a solid with real thickness, and on most animals it is thicker than you think - nearly as deep as the head itself. Two curves, one over, one under.
Watch out A thin stick neck, which makes any animal look fragile.
Check The neck should be nearly as thick as the head is tall.
-
Step 6
Run the outline along the top and bottom of the tiger.
This is where the animal stops being two eggs. Let the topline follow the spine you already drew and keep the belly line taut - a sagging belly is a decision, not an accident.
Watch out Ignoring the spine curve you drew and inventing a new back.
Check The topline should agree with the spine curve underneath it.
-
Step 7
Draw the belly line underneath.
The belly is a separate decision from the masses: it hangs below the line joining them, sagging most midway, and how much it sags is part of the animal - taut on a deer, generous on a cow. Draw it as one curve, not two arcs meeting.
Watch out A straight line between the ovals, which reads as a table.
Check The belly should dip below both mass bottoms at its middle.
-
Step 8
Seal the outline: one curve at the front, one at the rear.
Two curves seal the body into one shape: down the front of the chest into the belly, and from the top of the hips around the rump to meet it. Without them the animal has no front or back and the legs float - this is the step that turns parts into a body.
Watch out Leaving the ends open because the ovals suggest them.
Check You should be able to trace the whole body without lifting your pen.
-
Step 9
Add the front legs, joint by joint.
Legs are chains of segments with a joint at each bend, and every leg bends somewhere. Draw joint to joint in straight strokes first; curves come later if at all.
Watch out Straight tube legs with no joints, which read as furniture.
Check Each front leg should bend at least once.
-
Step 10
Add the rear legs, checking their length against the front.
The hind legs fold the opposite way to the front pair - the hock points backwards. Compare their length against the front legs rather than judging them alone.
Watch out Back legs bending the same way as the front ones.
Check Front and back feet should reach the same ground line.
-
Step 11
Draw both ears, comparing the second to the first.
Ears attach further back on the skull than feels natural, and their shape is one of the strongest species signals you have. Draw the second by comparing it to the first.
Watch out Planting the ears on top of the head like handles.
Check Both ears should attach behind the midpoint of the skull.
-
Step 12
Add the muzzle and the face.
The muzzle projects forward from the lower half of the head mass. Its length relative to the skull is the proportion to measure - it is the one that changes species when you get it wrong.
Watch out A muzzle pointing down instead of forward.
Check The eye should sit in the top half of the head mass.
-
Step 13
Add the tail and the tiger markings.
Detail is suggested, never itemised. Put the marks where they identify the animal and stop early - texture spread evenly everywhere flattens the drawing back out.
Watch out Covering the body evenly in fur marks.
Check Step back: the big shapes should still read first.
-
Step 14
Go round the keepers heavily, then erase the guides.
Press harder on the outline and the face, leave the small marks light, and erase the construction ovals. That weight difference is what makes the drawing look decided.
Watch out Going over every line at the same weight.
Check The outline should be clearly darker than the interior marks.
What it looks like finished
The same drawing with every guide erased and only the lines you meant to keep, at the weight you meant them to be. If yours still has centre lines and blocking-in shapes in it, this is the step you have not done yet - and it takes about thirty seconds.
Yours will not look like this, and it is not supposed to. This is the construction with the scaffolding taken away, not a drawing somebody made to be admired - the point is to show you which of your lines were guides.
What this one actually teaches you
The skill under the subject is comparison: each new part is judged against one already on the page, never against your idea of the animal. That habit is what fixes proportion everywhere.
The tiger closes the animal set by combining its hardest lessons: the lion's cat construction, the zebra's pattern-on-form, the eagle's brow-line expression. It is deliberately the last animal to draw, and the one that shows whether the family method compounded.
Practise these: Line confidence Proportion Value range
What you need
A pencil, kept light until the last step, and an eraser you will actually use. The construction is deliberately drawn to be removed.
If it's going wrong
If the stripes look like a zebra's, they connect too much: tiger stripes are short, broken and tapered, hanging from the spine line rather than wrapping the whole barrel.
If it reads as a house cat, scale the paws up: a tiger's forepaws are enormous relative to the leg, and the head is small relative to the chest.
If the face is not fierce, it is the same eagle trick: a flat brow line over the eyes. Round-eyed tigers read as cubs no matter what else you do.
Print the steps
Take it away from the screen. The step sheet prints on one page.
Questions people ask
- How do I draw tiger stripes?
- Short, broken and tapered at both ends, hanging top-down off the spine like pulled paint - densest over shoulders and haunches, sparse on the legs. Connected wrap-around stripes are a zebra's.
- Why does my tiger look like a house cat?
- Paws too small and head too big. A tiger's forepaws are enormous against the leg, and the head is small against the chest - both ratios are the opposite of a pet's.
- How do I make a tiger's face look fierce?
- A flat brow line over each eye, the eagle trick - expression from structure, not from detail. Round-eyed tigers read as cubs.
- How many steps does it take to draw a tiger?
- Twelve here: two body masses, the spine, the head and neck, the silhouette, four legs in two pairs, then features, detail and line weight. About 17 minutes at a comfortable pace.
- Where do the legs attach on a tiger?
- To the two masses, not the outline - front legs to the chest oval, back legs to the pelvis. Legs hung from the belly line are why animal drawings collapse.
- Can a beginner draw a tiger?
- Yes - the construction is two ovals and a curve, and there is a finish-early step marked partway through that leaves you with a complete drawing rather than an abandoned one.
- Do I need to draw fur on a tiger?
- Only at the silhouette edge, and only where the coat is genuinely long. Fur drawn all over turns any animal into a rug.
- What should I practise before drawing a tiger?
- Five minutes of ellipses or line control. The whole build is ovals and committed curves, and warm hands make it a different exercise.