How to Draw a Shark
1 / 13
Lay in one oval for the whole body.
The body should be symmetrical about its long axis.
Op papier te trek in plaas daarvan?
Ons maak die foto reguit en maak dit vir jou skoon, papier tel presies dieselfde
Aangaande hierdie tekening
A shark is a torpedo with a triangle on top, and the whole menace lives in three choices: the dorsal fin is tall and swept back, the mouth sits UNDER the head rather than on its front, and the tail's top lobe is much longer than its bottom one. Miss any of the three and you have drawn a friendly fish.
Underneath, this is an oval and a tail like every swimmer on the site; the species is in the fins, the mouth and the markings.
Stap met stap
-
Stap 1
Lay in one oval for the whole body.
One long oval, drawn fast. Fish bodies are smooth in a way hands are bad at producing slowly, so go round the shape in one continuous motion and keep the best pass.
Pas op A lumpy body built from careful short strokes.
Gaan na The body should be symmetrical about its long axis.
-
Stap 2
Draw the tail shape.
The tail is bigger than you think - often a third of the body's length. An undersized tail is the single thing that makes a drawn fish read as a leaf.
Pas op A small tail tucked against the body.
Gaan na The tail should be about a third of the body length.
-
Stap 3
Add one curve for the gill.
One curve, following the round of the head, roughly a fifth of the way along. It separates head from body and does more work than any other single line on the fish.
Pas op A straight gill line, which flattens the head.
Gaan na The gill curve should bow the same way as the nose.
-
Stap 4
Draw the eye and its pupil.
High and forward - roughly where the gill curve meets the top third. Round, dark centre, one highlight. Too low or too far back and the fish stops looking alert.
Pas op Centring the eye in the head.
Gaan na The eye should sit above the body's midline.
-
Stap 5
Draw the mouth at the front.
The mouth sits at the very front, lower than the eye, and it is smaller than instinct says. A short curve is enough - an open grin turns the fish into a cartoon.
Pas op A large smiling mouth.
Gaan na The mouth should be below and forward of the eye.
-
Stap 6
Draw the dorsal fin.
Start the fin lines INSIDE the body so they cross the outline. That overlap is what attaches the fin - drawn outside the line it floats like a flag.
Pas op A fin sitting on the outline without crossing it.
Gaan na Fin lines should visibly cross the body outline.
-
Stap 7
Add the lower fin.
Compare it to the top fin, not to your idea of a fin: position, rake and size all read against the one you already drew.
Pas op A bottom fin that mirrors the top exactly - they rarely match in nature.
Gaan na The two fins should differ, deliberately.
-
Stap 8
Put the small side fin on.
The pectoral fin is the smallest and it sits just behind the gill curve, angled back. It is the one nearest the viewer, so it draws over the body.
Pas op Making the side fin as big as the others.
Gaan na It should be clearly the smallest fin.
-
Stap 9
Draw some texture on the body.
Suggest, never itemise. A handful of marks near the head lets the eye tile the rest of the body; drawing every scale turns the fish into a texture swatch.
Pas op Covering the whole body in scales.
Gaan na Most of the body should still be empty.
-
Stap 10
Put in the features specific to a shark.
Species markings follow the body's curve and fade toward the belly. Put them on deliberately - they are the difference between a fish and this fish.
Pas op Markings drawn flat across a curved body.
Gaan na Stripes or patches should bend with the form.
-
Stap 11
Add tone under the body.
The underside is darker - light comes from above, even underwater in a drawing. One soft band of tone along the belly makes the whole fish read as round.
Pas op Even tone everywhere, which flattens the body.
Gaan na The belly should be clearly darker than the back.
-
Stap 12
Draw three bubbles and two ripples, and stop.
Three bubbles of different sizes rising off the mouth and two long ripple lines are the entire ocean - more reads as boiling. The bubbles shrink as they rise, and the ripples drift horizontal, which is what places the shark in water instead of in white space.
Pas op A column of same-size bubbles, or ripples that wave like flags.
Gaan na The bubbles should get smaller as they rise.
-
Stap 13
Press harder on what stays, remove what does not.
Darken the silhouette and the tail, keep pattern marks light, erase the construction oval. Weight contrast finishes the drawing.
Pas op Every line at the same weight.
Gaan na The outline should dominate when you squint.
Wat dit lyk voltooi
Dieselfde tekening met elke gids uitgevee en slegs die lyne wat jy bedoel het om te hou, op die gewig wat jy bedoel het hulle om te wees. As joune nog steeds sentrum lyne en blokvorme daarin het, is dit die stap wat jy nog nie gedoen het nie - en dit neem omtrent dertig sekondes.
Jouwe sal nie so lyk nie, en dit is nie veronderstel om te nie. Dit is die konstruksie met die stellasie wat weggeneem is, nie'n teken wat bewonder moet word nie - die punt is om jou te wys watter van jou lyne gidse was.
Wat hierdie een jou werklik leer
What transfers is suggestion over itemisation - a few scale marks that let the eye tile the rest. The same restraint draws leaves, hair and crowds.
The shark is the site's cleanest demonstration that identity lives in a handful of decisions, not in detail: vertical tail, underslung mouth, swept dorsal. Three facts, correctly placed, beat an hour of texture.
Oefen hierdie: Line confidence Proportion Value range
Wat jy nodig het
A pencil and any paper, or a finger on the canvas above - nothing here needs special equipment. Keep the construction light if you are on paper, because the guides come off at the end.
As dit verkeerd gaan
If it looks like a dolphin, the tail is wrong: a shark's tail is VERTICAL with a long top lobe, where a dolphin's is horizontal. That one fact separates the two silhouettes.
If it looks cute, the mouth is on the front of the face. A shark's mouth is underslung - it sits below the head, well back from the nose tip.
If the body looks stiff, the spine has no curve. Even cruising, a shark's body is one long S from nose to tail - flat torpedoes read as submarines.
Druk die stappe
Neem dit weg van die skerm. Die stap staat druk op een bladsy.
Vrae wat mense vra
- How do I draw a shark's tail?
- Vertical, with the top lobe much longer than the bottom - the opposite of a dolphin's horizontal tail. This single choice decides which animal you drew.
- Where does a shark's mouth go?
- Under the head, well back from the nose, as one long downward arc with a few tooth ticks. A mouth on the front of the face makes it a cartoon.
- How do I draw the gills on a shark?
- Five short parallel curves just before the side fin, angled with the body. They are the only texture the drawing needs.
- How do I start drawing a shark?
- One body oval, drawn fast in one motion, then the tail before any detail. Everything else - fins, gill, eye - attaches to that oval by overlapping it, which is what keeps the parts reading as one animal.
- How big should the tail be on a shark?
- Bigger than feels right - about a third of the body length. An undersized tail is what makes a drawn fish read as a leaf.
- Do I have to draw all the scales on a shark?
- No, and you should not. A few marks near the head let the eye tile the rest of the body on its own; drawing every scale turns the animal into a texture swatch and loses the big shape you built first.
- Can a beginner draw a shark?
- Yes - it is one oval, a triangle and some overlapping fins, with a finish-early step marked partway through.
- Why do the fins on my shark look stuck on?
- They are not crossing the body outline. Start each fin line inside the body so it visibly overlaps the oval - that overlap is the attachment, and it is the single trick this whole family of lessons keeps reusing.