How to Draw a Shark
1 / 13
Lay in one oval for the whole body.
The body should be symmetrical about its long axis.
Tegning på papir i stedet?
Vi retter og rydder op på billedet for dig. Papiret tæller præcis det samme.
Om denne tegning
A shark is a torpedo with a triangle on top, and the whole menace lives in three choices: the dorsal fin is tall and swept back, the mouth sits UNDER the head rather than on its front, and the tail's top lobe is much longer than its bottom one. Miss any of the three and you have drawn a friendly fish.
Underneath, this is an oval and a tail like every swimmer on the site; the species is in the fins, the mouth and the markings.
Trin for trin
-
Trin 1
Lay in one oval for the whole body.
One long oval, drawn fast. Fish bodies are smooth in a way hands are bad at producing slowly, so go round the shape in one continuous motion and keep the best pass.
Pas på. A lumpy body built from careful short strokes.
Kontrol The body should be symmetrical about its long axis.
-
Trin 2
Draw the tail shape.
The tail is bigger than you think - often a third of the body's length. An undersized tail is the single thing that makes a drawn fish read as a leaf.
Pas på. A small tail tucked against the body.
Kontrol The tail should be about a third of the body length.
-
Trin 3
Add one curve for the gill.
One curve, following the round of the head, roughly a fifth of the way along. It separates head from body and does more work than any other single line on the fish.
Pas på. A straight gill line, which flattens the head.
Kontrol The gill curve should bow the same way as the nose.
-
Trin 4
Draw the eye and its pupil.
High and forward - roughly where the gill curve meets the top third. Round, dark centre, one highlight. Too low or too far back and the fish stops looking alert.
Pas på. Centring the eye in the head.
Kontrol The eye should sit above the body's midline.
-
Trin 5
Draw the mouth at the front.
The mouth sits at the very front, lower than the eye, and it is smaller than instinct says. A short curve is enough - an open grin turns the fish into a cartoon.
Pas på. A large smiling mouth.
Kontrol The mouth should be below and forward of the eye.
-
Trin 6
Draw the dorsal fin.
Start the fin lines INSIDE the body so they cross the outline. That overlap is what attaches the fin - drawn outside the line it floats like a flag.
Pas på. A fin sitting on the outline without crossing it.
Kontrol Fin lines should visibly cross the body outline.
-
Trin 7
Add the lower fin.
Compare it to the top fin, not to your idea of a fin: position, rake and size all read against the one you already drew.
Pas på. A bottom fin that mirrors the top exactly - they rarely match in nature.
Kontrol The two fins should differ, deliberately.
-
Trin 8
Put the small side fin on.
The pectoral fin is the smallest and it sits just behind the gill curve, angled back. It is the one nearest the viewer, so it draws over the body.
Pas på. Making the side fin as big as the others.
Kontrol It should be clearly the smallest fin.
-
Trin 9
Draw some texture on the body.
Suggest, never itemise. A handful of marks near the head lets the eye tile the rest of the body; drawing every scale turns the fish into a texture swatch.
Pas på. Covering the whole body in scales.
Kontrol Most of the body should still be empty.
-
Trin 10
Put in the features specific to a shark.
Species markings follow the body's curve and fade toward the belly. Put them on deliberately - they are the difference between a fish and this fish.
Pas på. Markings drawn flat across a curved body.
Kontrol Stripes or patches should bend with the form.
-
Trin 11
Add tone under the body.
The underside is darker - light comes from above, even underwater in a drawing. One soft band of tone along the belly makes the whole fish read as round.
Pas på. Even tone everywhere, which flattens the body.
Kontrol The belly should be clearly darker than the back.
-
Trin 12
Draw three bubbles and two ripples, and stop.
Three bubbles of different sizes rising off the mouth and two long ripple lines are the entire ocean - more reads as boiling. The bubbles shrink as they rise, and the ripples drift horizontal, which is what places the shark in water instead of in white space.
Pas på. A column of same-size bubbles, or ripples that wave like flags.
Kontrol The bubbles should get smaller as they rise.
-
Trin 13
Press harder on what stays, remove what does not.
Darken the silhouette and the tail, keep pattern marks light, erase the construction oval. Weight contrast finishes the drawing.
Pas på. Every line at the same weight.
Kontrol The outline should dominate when you squint.
Hvordan det ser ud færdigt
Den samme tegning med hver eneste guide slettet og kun de linjer, du ønskede at holde, ved den vægt, du mente, at de skulle være. Hvis din stadig har midterlinjer og blokerende former i det, er dette det trin, du ikke har gjort endnu - og det tager omkring 30 sekunder.
Din vil ikke se sådan ud, og det er ikke meningen at det skal. Dette er konstruktionen med stilladser taget væk, ikke en tegning nogen lavet til at blive beundret - pointen er at vise dig, hvilke af dine linjer var guider.
Hvad denne her faktisk lærer dig
What transfers is suggestion over itemisation - a few scale marks that let the eye tile the rest. The same restraint draws leaves, hair and crowds.
The shark is the site's cleanest demonstration that identity lives in a handful of decisions, not in detail: vertical tail, underslung mouth, swept dorsal. Three facts, correctly placed, beat an hour of texture.
Øv dig på disse: Line confidence Proportion Value range
Hvad du har brug for
A pencil and any paper, or a finger on the canvas above - nothing here needs special equipment. Keep the construction light if you are on paper, because the guides come off at the end.
Hvis det går galt
If it looks like a dolphin, the tail is wrong: a shark's tail is VERTICAL with a long top lobe, where a dolphin's is horizontal. That one fact separates the two silhouettes.
If it looks cute, the mouth is on the front of the face. A shark's mouth is underslung - it sits below the head, well back from the nose tip.
If the body looks stiff, the spine has no curve. Even cruising, a shark's body is one long S from nose to tail - flat torpedoes read as submarines.
Udskriv trinene
Tag den væk fra skærmen.
Spørgsmål folk spørger
- How do I draw a shark's tail?
- Vertical, with the top lobe much longer than the bottom - the opposite of a dolphin's horizontal tail. This single choice decides which animal you drew.
- Where does a shark's mouth go?
- Under the head, well back from the nose, as one long downward arc with a few tooth ticks. A mouth on the front of the face makes it a cartoon.
- How do I draw the gills on a shark?
- Five short parallel curves just before the side fin, angled with the body. They are the only texture the drawing needs.
- How do I start drawing a shark?
- One body oval, drawn fast in one motion, then the tail before any detail. Everything else - fins, gill, eye - attaches to that oval by overlapping it, which is what keeps the parts reading as one animal.
- How big should the tail be on a shark?
- Bigger than feels right - about a third of the body length. An undersized tail is what makes a drawn fish read as a leaf.
- Do I have to draw all the scales on a shark?
- No, and you should not. A few marks near the head let the eye tile the rest of the body on its own; drawing every scale turns the animal into a texture swatch and loses the big shape you built first.
- Can a beginner draw a shark?
- Yes - it is one oval, a triangle and some overlapping fins, with a finish-early step marked partway through.
- Why do the fins on my shark look stuck on?
- They are not crossing the body outline. Start each fin line inside the body so it visibly overlaps the oval - that overlap is the attachment, and it is the single trick this whole family of lessons keeps reusing.